Teeter Hang Ups ComforTrak EP-560 Assembly Instructions Manual page 11

FIGURE 8
FIGURE 9 FIGURE 10
FIGURE 11
A B C
1 Bracket Pin
STEP 3 Roller Hinge Assembly
FIGURE 7
Unlocked
Pivot Pin
• Familiarize yourself with the Roller Hinge and Cam Lock terms detailed below in Figure 7.
• For ease of assembly, rest the Table Bed against the Crossbar (Figure 8) at the front of the
A-Frame.
• On one side of the Table Bed, lift and hold the Cam Lock up all the way to unlock (Figure 9).
• In your other hand, hold one 3-Hole Roller Hinge at the Pivot Pin. With the Pivot Pin facing out
(away from the Table Bed), slide the bottom of the Roller Hinge between the Cam Lock and
the Bracket.
TIP: Make sure that the Cam Lock is completely open when inserting the Roller Hinge,
otherwise assembly will be more difficult.
• Engage one of the holes in the Roller Hinge over the Bracket Pin. Figure 11 shows the Roller
Hinge installed correctly, with the Bracket Pin engaged in Setting C.
NOTE: Refer to the Owner's Manual for an explanation of the hole settings. If you are unsure,
use Setting C to start.
1
• Push down on the Cam Lock (Figure 10) to lock it and secure the Roller Hinge.
• Repeat on other side. Make sure the Roller Hinges are in the same hole setting on both sides.
Locked
Bracket Pin
Cam Lock
Bracket
10
WARNING
!
NEVER disassemble the
Roller Hinge Pivot Pin.