Teeter Hang Ups ComforTrak EP-560 Assembly Instructions Manual page 15

FIGURE 22
1
FIGURE 22a
1 Front Ankle Bar Housing
Large Arrow: Pull up on the T-Pin.
Small Arrow: Insert the Front Ankle
Bar into the Front Ankle Bar Housing.
FIGURE 23
FIGURE 23a
1 Retainer Spring & Cable Loop
2 Temporary Zip-Tie
FIGURE 24
FIGURE 24a
STEP 7 Front Ankle Bar Assembly
Assemble the Front Ankle Bar onto the Main Shaft
NOTE: Extending out from the Front Ankle Bar, you will see a temporary plastic zip-tie
fastened to the loops of the Retainer Spring with Cable. This is provided to assist with the
assembly process, detailed below.
• Locate the Front Ankle Bar Assembly Hardware Kit (HK1004).
• With hole settings of the Front Ankle Bar facing up, insert the temporary plastic zip-tie and
Front Ankle Bar into the Front Ankle Bar housing (Figure 22) of the Main Shaft.
• Pull up on the T-Pin Lock to allow the Front Ankle Bar to insert all the way into the housing.
Release the T-Pin to engage in the hole setting closest to the Front Ankle Cups (Figure 22a).
• Turn over the Main Shaft (Figure 23). From the back side of the Front Ankle Bar housing,
pull the plastic zip-tie to stretch the Retainer Spring and Cable Loops so that they align with
the bolt holes in the back of the Front Ankle Bar housing.
• Insert the Bolt through the hole in the outer side of the housing, through both the Retainer
Spring and Cable Loops, and through the hole in the other side of the housing (Figure 23a).
1
• Release your hold on the plastic zip-tie. Secure the Bolt with the Nut (Figure 24) using the
10/13mm Open-Ended Wrench provided.
2
IMPORTANT: Cut the long segment of zip-tie off so that it will not interfere with the function
of the Retainer Spring. Be careful not to damage the Retainer Spring with the Cable.
• Cover the open end of the Front Ankle Bar Housing with the End Cap (Figure 24a).
WARNING
!
Failure to assemble the T-Pin Ankle Lock System
properly could result in serious injury or death!
14