Teeter Hang Ups ComforTrak EP-560 Assembly Instructions Manual page 13

STEP 5
FIGURE 16
FIGURE 16a
FIGURE 16b
FIGURE 17
Ankle Comfort Dial Assembly
Depending on the model you have purchased, the items in this step will vary.
EP-560: Complete Steps 5-7.
EP-560 Sport: Complete these steps to use the T-Pin Ankle Lock System, or if using
with the EZ-Up Gravity Boots, skip to Step 8. To assemble the Conversion Bar, refer to the
additional instructions enclosed.
Assemble the Ankle Comfort Dial onto the Main Shaft
• Locate the Ankle Comfort Dial Assembly Hardware Kit (HK1005).
• Slide the Ankle Comfort Dial Bar with pre-assembled Ankle Comfort Dial into the
hole at the front base of the Main Shaft (Figure 16a).
• The Ankle Comfort Dial is designed with a High and Low setting. Position the pre-assembled
Dial in the Low Setting (screw holes facing up) for ease of assembly.
• Slide the separate Ankle Comfort Dial onto the Ankle Comfort Dial Bar (Figure 16b) and align
the screw holes.
• Secure with the screw and tighten with the screwdriver provided (Figure 17).
NOTE: Refer to the Owner's Manual for a complete description of the Ankle Comfort Dial
settings.
12