The following information can be displayed at the control valve or remote display. These settings are
read-only. Press the DOWN ARROW or CHECK MARK button to scroll through the settings. Press
the UP ARROW button to view the previous setting.
Function
Screen Display
Button
softening
Apr-05-10 12:34A
>1)informAtion
2)mAnuAl mode
sAlt tAnk level
ok
remAin cApAcity
80%
remAin cApAcity
708
current
flowrAte
10.8
Range
N/A
This is the HOME SCREEN. Press any but-
ton except the CANCEL (X) button to ad-
vance to the MAIN MENU SCREEN.
Press the DOWN ARROW button once to
1–6
1) INFORMATION.
Press the CHECK MARK button to display
the Information screens.
If a Salt Brine Tank is installed, this screen
1–12
displays the salt level. The screen displays
OK unless the SBT probe detects an over-
filled brine tank or low salt level. This screen
is displayed only if a Smart Brine Tank is
installed.
If the screen displays LOW, the subsequent
screen will display
APPROX DAYS OF SALT REMAINING.
The softening capacity remaining, displayed
0–100
as a percentage of the total capacity. Dur-
ing manually initiated regeneration, assume
0 percent remaining capacity.
Press the DOWN ARROW button to dis-
play the next screen.
The softening capacity remaining, measured
0–no limit
in gallons (liters).
Press the DOWN ARROW button to dis-
play the next screen.
The current flow rate, measured in gallons
0–no limit
(liters) per minute.
Press the DOWN ARROW button to dis-
play the next screen.
Setting Description
Information
01023052
39