Culligan 9" Owner's Manual page 35

Function
Screen Display
Button
unit type
>softener
vAlve type
>globAl
units
>us inch
resin in tAnk
>1.00
hArdness gpg
>25 (1000 gAl)
Range Procedure
Set Unit Type
If the displayed value is not correct, press
the CHECK MARK button. Press the
DOWN ARROW button to change the unit
type. The screen displays the changed set-
Filter or
ting (in this example, leave at the default,
Softener
softener). Press the CHECK MARK button
to accept the value and advance to the next
setting, VALVE TYPE.
Set Valve Type
If the displayed value is not correct, press
the CHECK MARK button. Press the UP
ARROW or DOWN ARROW button to
4-cycle,
change the valve type. The screen displays
5-cycle,
the new valve type (leave the HE setting at
Plat Plus,
the default, GLOBAL). Press the CHECK
Global
MARK button to accept the value and ad-
vance to the next setting, UNITS.
Set Units
If the displayed value is not correct, press
the CHECK MARK button. Press the
DOWN ARROW button to change the
measurement units. The screen displays the
US Inch or
changed setting (in this example, leave at
METRIC
US Inch). Press the CHECK MARK button
to accept the value and advance to the next
setting.
Set Softener Resin Value
If the displayed value is not correct, press
the CHECK MARK button. Press the UP
ARROW or DOWN ARROW button to
change the new softener resin volume. This
0.10–
setting increments by tenths until 4.00 cubic
4.00
feet, and then increments by whole numbers.
4.10–
The screen displays the changed setting
200.00
(leave the HE setting at the default, 1.00).
Press the CHECK MARK button to accept
the value and advance to the next setting.
Set Water Hardness
If the displayed value is not correct, press
the CHECK MARK button. Press the UP
ARROW or DOWN ARROW button to
change the water hardness setting. The
1–170
screen displays the changed setting (leave
the HE setting at the default, 25 (1000 gal-
lons)). Press the CHECK MARK button.
01023052
35