Disassembly Procedure - Yamaha O2R96 Service Manual

02R96

DISASSEMBLY PROCEDURE

Note: Take care not to trap your fingers.
After replacing the circuit board or fader of FD1 or
FD2, please initialize them. (See page 134.)
Disassembling the 02R96
1. Removing the SP02R96
(Time required: About 5 minutes)
1-1. If the SP02R96 is attached to the 02R96, remove
the twelve (12) screws marked [A], and then both
sides must be removed. (Fig.1)
2. Removing the MB02R96
(Time required: About 5 minutes)
2-1. Remove the two (2) screws marked [35] and the two
(2) screws marked [75]. The MB02R96 can then be
removed from the 02R96. (Photo.1,2)
Photo.1
3. Control Panel Assembly
(Time required: About 10 minutes)
3-1. Remove the SP02R96. (See procedure 1.)
3-2. Remove the MB02R96. (See procedure 2.)
3-3. Remove the fourteen (14) screws marked [70A], the
seven (7) screws marked [70B] and the five (5)
screws marked [70C]. (Fig.2)
3-4. Hold the LCD assembly part, and lift the control panel
assembly. And then, fasten them by the two (2) front
stays. (Photo.3)
When assembling the control panel assembly
with the side panel, put the screws of the
round screw hole of the side panel in place
first, then the screws of the elliptic screw hole.
34
[A]: Bind Head Screw
Fig.1
Meter angle L, R
[35]:Bind Head Screw
[75]:Bind Head Screw
02R96
SP02R96(Side pad)
SP02R96
[A]
(MB side pad)
PW 4.0X20 MFZN2BL (VA314000)
MB02R96
[75]
[35]
02R96
A4.0X12 MFZN2BL (VP156900)
A4.0X12 MFZN2BL (VP156900)
Photo.2