Canon SmartBase MPC600F Service Manual page 99
Hide thumbs
Also See for SmartBase MPC600F:
- Parts catalog (76 pages) ,
- Service manual (179 pages) ,
- Service manual (9 pages)
Table of Contents
Advertisement
SmartBase MPC600F/MPC400 Chapter 4: Maintenance & Service
No.
##283
##284
##285
##286
##287
##288
##289
##290
• Printer error codes
No.
##332
##333
##334
##335
##336
##337
UNQ
##342
##345
##346
##348
• V.8/V.34 protocol error codes
No.
##670
##671
##672
##673
##674
##675
Download Service Manual And Resetter Printer at http://printer1.blogspot.com
Tx or Rx
Definition
[ TX
]
Excessive repeat protocol during Tx
[ TX
]
DCN reception after TCF transmission
[ TX
]
DCN reception after EOP transmission
[ TX
]
DCN reception after EOM transmission
[ TX
]
DCN reception after MPS transmission
[ TX
]
Receive signals other than PIN, PIP, MCF, RTP or RTN after EOP
transmission
[ TX
]
Receive signals other than PIN, PIP, MCF, RTP or RTN after EOM
transmission
[ TX
]
Receive signals other than PIN, PIP, MCF, RTP or RTN after MPS
transmission
Tx or Rx
Definition
[TX/RX ]
Printer control DRAM check error
[TX/RX ]
Printer control ROM check error
[TX/RX ]
Printer control EEPROM check error
[TX/RX ]
Data transmission error between the system control section and printer
control section
[TX/RX ]
BJ head abnormal temperature error
[RX
]
BJ head temperature sensor error
[TX/RX ]
Cleaning absorption waste ink capacity full
[TX/RX ]
BJ cartridge head cleaning error
[TX/RX ]
Inside temperature error
[TX/RX ]
Ink detection sensor error
Tx or Rx
Definition
[ TX
]
At V.8 late start, the called party declares the V.8 protocol in DIS
signal and this unit transmits a CI signal, but the protocol does not
progress and a T1 time-out occurs.
[ RX
]
At V.8 termination, the protocol did not advance to phase 2 and a T1
time-out occurs after the caller CM signal was detected.
[ TX
]
The protocol did not move from phase 2 to phase 3 and a T1 time-out
occurred during V.34 transmission.
[ RX
]
The protocol did not move from phase 2 to phase 3 and a T1 time-out
occurred during V.34 reception.
[ TX
]
The protocol did not move from phase 3 to phase 4 and a T1 time-out
occurred during V.34 transmission.
[ RX
]
The protocol did not move from phase 3 to phase 4 and a T1 time-out
occurred during V.34 reception.
4-20
Advertisement
Table of Contents
