Canon SmartBase MPC600F Service Manual page 97

SmartBase MPC600F/MPC400 Chapter 4: Maintenance & Service
• EPT (Echo Protect Tone)
Change service data #1 SSSW SW03 bit 1.
Bit 1:1
0
• Adjust NL equalizer.
Set service data #2 MENU Parameter No.05 to "ON".
• Reduce the transmission start speed.
Reduce the transmission speed by changing user data "FAX SETTINGS" "TX SETTINGS" "TX
START SPEED".
• Loosen the TCF judgment standard.
Not available for this fax.
• Loosen the RTN transmission conditions.
Change service data #3 NUMERIC Param. Parameter No.02 to 04.
No.02 Percentage of errors in all lines
No.03 Number of lines of burst condition
No.04 Lines below the burst condition
• Increase the no-sound time after CFR reception.
Change service data #1 SSSW SW04 bit 4 to "1".
Bit 4:1
0
Download Service Manual And Resetter Printer at http://printer1.blogspot.com
Transmit an echo protect tone.
Not transmit an echo protect tone.
Time when the low-speed signal is ignored after sending a CFR signal: 1500 ms
Time when the low-speed signal is ignored after sending a CFR signal: 700 ms
: Set close to 99%.
: Set close to 99 lines.
: Set close to 99 times.
4-18