Canon SmartBase MPC600F Service Manual page 122

#1 SSSW (service soft switch setting)
SW26 (service soft switch 26: Transmission function setting)
Bit
0
1
2
3 (New) Prohibit broadcast
4
5
6
7
[Bit 3]
You may disable selection of multiple addresses to prevent broadcasting by mistake (on the part of
the user); however, this setting will not affect broadcasting by group dialing.
SW28 (service soft switch 28: V.8/ V.34 protocol settings)
Bit
0 (New) Caller V.8 protocol
1 (New) Called party V.8 protocol
2 (New) Caller V.8 protocol late start
3 (New) Called party V.8 protocol late start NO
4 (New) V.34 reception fallback
5
6
7
[Bit 0]
Select whether to use the V.8 protocol when calling. If NO is selected, the V.8 protocol is inhibited
at calling and the V.21 protocol is used.
[Bit 1]
Select whether to use the V.8 protocol when called. If NO is selected, the V8 protocol is inhibited
when called and the V.21 protocol is used.
[Bit 2]
If ANSam signal is not received during transmission (mainly manual transmission), select whether
to use the V.8 protocol when the other fax machine declares the V.8 protocol in DIS signal. If NO
is selected, the CI signal is not transmitted and the V.8 protocol is not used even if the DIS that
specifies the V.8 protocol is received.
Download Service Manual And Resetter Printer at http://printer1.blogspot.com
SmartBase MPC600F/MPC400 Chapter 4: Maintenance & Service
Function
Compulsory direct transmission
Not used
Not used
Not used
Not used
When STOP key is pressed
during a sequential broadcasting
Error transmission report when
transmission is stopped
Function
Not used
Not used
Not used
1
Set
Yes
Only cancel
communication
Not output
1
NO
NO
NO
Prohibited
4-43
0
Not set
No
Cancel all
communication
Output
0
YES
YES
YES
YES
Not prohibited