Sony nxcam HXR-NX3D1E Operating Manual page 26

Tips

See page 98 on the recordable time of 2D movies.

You can record photos during movie recording by pressing PHOTO fully (Dual Rec, p. 40).

[ SteadyShot] is set to [Active] in the default setting.

You can specify the priority face by touching it (p. 39).

You can capture photos from recorded 2D movies (p. 50).

You can check the recordable time, estimated remaining capacity, etc., by touching

[Setup]  [
(
The LCD screen of your camcorder can display recording images across the entire screen (full pixel

display). However, this may cause slight trimming of the top, bottom, right and left edges of images
when played back on a TV which is not compatible with full pixel display. In the case of 2D recording,
set [Guide Frame] to [On] (p. 76), and record images using the outer frame displayed on the screen as a
guide.
To adjust the angle of the LCD panel, first open the LCD panel 90 degrees to the camcorder (), and

then adjust the angle ().
 90 degrees (max.)
 180 degrees (max.)
Watch 3D movies on the LCD screen squarely from about 30 cm (11 7/8 in.) away.

Data code during recording
The recording date, time and condition are recorded automatically on the recording media.
They are not displayed during recording. However, you can check them as [Data Code]
during playback. To display them, touch
Settings)]  [Data Code]  a desired setting 
GB

Media Settings)]  [Media Info].
 90 degrees to the
camcorder
(MENU)  [Setup]  [

.
(MENU) 
( Playback