Backlight; Software Information; Fixture Hours; Led Test - Chauvet WELL FIT User Manual

Operation

Backlight

Software
Information

Fixture Hours

LED Test

Factory Reset

Configuration
(DMX)
DMX
Personalities

DMX Control

Wireless Settings

IR Setting

-14-
This setting allows
WELL Fit's display stays on after the last button is pressed on the control panel.
1. Go to the BackLite main level.
2. Select On (remains on), 10S (10 seconds), 20S (20 seconds), or 30S (seconds).
This option shows what version of software the WELL Fit is running.
1. Go to the Information main level.
2. Select Version and the version number will show on the display.
This option shows the total amount of hours the WELL Fit has been turned on.
1. Go to the Information main level.
2. Select Fixture Hours and the total number of hours will show on the display.
This option runs a check of the LEDs on the WELL Fit by turning on all the LEDs in sequence.
1. Go to the Information main level.
2. Select Test programming level.
This option runs a check of the LEDs on the WELL Fit by turning on all the LEDs in sequence.
1. Go to the Factory Reset main level.
2. Select On to reset the product to factory settings.
Use DMX configurations to operate the product with a DMX controller.
This setting allows you to choose a particular DMX personality.
1. Go to the DMX Channel main level.
2. Select the desired personality (4 Ch, 6 Ch, 10Ch, HSI, or HSV).
·
See the DMX Values
personality.
·
Make sure that the starting addresses on the various products do not overlap due to
the new personality setting.
In this mode, each product will respond to a unique starting address from the DMX controller. All
products with the same starting address will respond in unison.
1. Select a DMX personality as shown in
2. Set the starting address:
a. Go to DMX Address main level.
b. Select the starting address (001–512).
The highest recommended starting address for each DMX mode is as follows:
DMX Personality
4 Ch
6 Ch
10Ch
HSI
HSV
This mode allows you to control DMX wirelessly. For detailed setup of this feature see
Operation. To disable this feature:
1. Go to Wireless Setting > Receive.
2. Select Off.
This mode allows you to control the WELL Fit with an IR remote. For detailed setup of this
feature, see IR Infrared Remote
1. Go to IR Setting.
2. Select Off.
you to set the amount
section for the highest starting address you can select for each
DMX Personalities.
Control. To disable this feature:
of time the backlight
DMX Address
509
507
503
510
510
WELL Fit User Manual Rev. 1
on the
Wireless