Table of Contents
Advertisement
Main Level
Programming Levels
Fixture Hours
Version
Information
UID
Reset Factory
Configuration (DMX)
Use control configurations to operate the product with a DMX controller.
Control Personalities
This setting allows you to choose a particular control personality.
1.
Go to the DMX Personality main level.
2.
Select the desired personality (see table below).
•
See the
personality.
•
Make sure that the starting addresses on the various products do not overlap due to the
new personality setting.
Starting Address
Each product will respond to a unique starting address from the DMX controller. All products with the same
starting address will respond in unison.
1.
Go to the DMX Address main level.
2.
Select the starting address (001–512).
The highest recommended starting address for each DMX mode is as follows:
Page 8 of 16
Description
<_ _ _ _H>
Shows total hours the product has been on
<V_._>
Shows current firmware version
<_ _ _ _ _ _ _
Shows product UID
_>
No
Resets the product to factory default settings
Yes
Personality
3 Ch
4 Ch
5 Ch
6 Ch
Starting Address
section for the highest starting address you can select for each
Personality
3 Ch
4 Ch
5 Ch
6 Ch
Channels
3
4
5
6
Address
510
509
508
507
STRIKE P38 User Manual Rev. 1
Operation
Advertisement
Table of Contents
