Table of Contents
Advertisement
When the pilot is alight and stable, partially depress the knob and turn to "LOW". The
K
pilot should then light the main burner at its low setting. There may be a delay of up to
four seconds between the pilot lighting and ignition of the gas at the main burner. This is
normal and is due to the time required to fill the main burner compartment with sufficient
gas for ignition.
When the main burner is alight at its low setting, partially depress the knob and
K
gradually turn it anti-clockwise until the burner is at your desired level. The burner
flames will gradually increase until the knob reaches the "HIGH" position.
Note: The appliance will operate to its maximum potential if the flue is primed during the
first 20-30 minutes of operation. To do this, simply operate the appliance at its "High"
setting. This will also burn off any carbon deposits that may have formed during previous
operations. If operating the appliance for long
periods it is beneficial to change between settings.
This will help to remove any carbon deposits that
may form during operation.
To turn off
To turn the main burner off but leave the pilot
K
alight, partially depress the knob and turn to
PILOT/IGN.
To turn the fire fully off, partially depress the
K
knob and turn to OFF.
Wait at least three minutes before relighting.
K
While cooling, the coals may make some crackling
noises. This is quite normal.
Lighting with a taper
See figure 3.
In the unlikely event of failure of the ignition spark, the pilot can be lit by a taper or long
spill. Insert the taper or spill alongside of the left side wall of the fire box, Depress the
control knob, turn it to PILOT/IGN
OWNER'S GUIDE
Page 8
Figure 3. Lighting with a taper
Advertisement
Table of Contents
