Panasonic KX-TDE100 Pc Programming Manual page 19

6. a.
Select your PBX model from PBX Model.
b.
Select the LAN or RS-232C tab, depending on the type of PC connection with the PBX.
c.
Specify the settings as required. (See 2.1.1 Starting Maintenance Console and Software
Modes)
Note
When connecting to the PBX for the first time selecting LAN, the IP Address and Port
Number must be set to 192.168.0.101 and 35300 respectively.
d.
Enter the system password for installer (default: 1234).
e.
Click Connect.
7. When country/area data do not match:
a.
Click OK to replace the country/area data of the PBX. Replacement may take several minutes to
complete.
b.
Follow the procedure described in Section 3.16.1 Starting the PBX (for KX-TDE100/KX-TDE200)
or Section 3.18.1 Starting the PBX (for KX-TDE600) in the Installation Manual and restart the PBX.
c.
Repeat step 5 to reconnect the Maintenance Console to the PBX.
8. Follow the instructions of the Quick Setup wizard for the basic items in Quick Setup—Step 1 to 3.
9. In Quick Setup—Step 4, the IP addressing information for the IPCMPR/IPCEMPR card can be assigned
automatically through a DHCP server or entered manually.
When using a DHCP server:
a.
Select Enable for the DHCP Client setting.
b.
Click Apply.
Note
The boxes will turn grey and the IP addresses will
be assigned automatically after the PBX is reset.
When not using a DHCP server:
a.
Select Disable for the DHCP Client setting.
b.
For KX-TDE100/KX-TDE200, type the IP address of the
IPCMPR card in the IP Address for IPCMPR Card box.
For KX-TDE600, type the IP address of the IPCEMPR
card in the IP Address for IPCEMPR Card box.
c.
In the IP Address for VoIP-DSP box, type the IP
address of the DSP16 or DSP64 card.
d.
In the Subnet Mask box, type the subnet mask address
of the network.
e.
In the Default Gateway box, type the IP address of the
default gateway.
f.
Click Apply.
10. Follow the instructions of the Quick Setup wizard in Quick Setup.
The system menu appears. You may now begin programming the PBX.
Notice
•
Do not change the IP addresses of the IPCMPR/IPCEMPR and DSP cards once IP telephones are
registered to the PBX using these IP addresses.
*3
*4
1.2.1 Installing and Starting the Maintenance Console
*1
*2
PC Programming Manual 19