Konica Minolta bizhub C451 User Manual page 501

Application functions
What happens when "Auto" is selected?
?
% The factory default setting is "Auto". Touch [Auto] to automatically
determine the binding position according to the orientation of the
loaded document. If the document length is 11-11/16 inch or less,
a binding position along the long side of the paper is selected. If the
document length is more than 11-11/16 inch, a binding position
along the short side of the paper is selected.
4
Touch [-] or [+] to specify the binding margin width.
– If "None" is selected, the binding margin width is set to 0 inch.
When making double-sided copies, the image orientation can ad-
justed without creating a binding margin.
– If a decimal value is displayed in the screen, use the keypad to type
in the setting. For details on switching between decimal and frac-
tion values, refer to "System Settings" on page 11-20.
– If a decimal value is displayed in the screen and the specified value
is outside the allowable range, the message "Input Error" appears.
Type a value within the allowable range. If the value was incorrectly
entered, press the [C] (clear) key to erase the value, and then spec-
ify the correct value.
How can the entered margin position be corrected?
?
% Without changing the margin width, change the margin position.
5
If necessary, touch [Image Shift].
The Image Shift screen appears.
6
Adjust the position of the image, and then touch [OK].
– Touch [Left], [Right], [Top] or [Bottom] to select the direction to be
adjusted, and then use the keypad or touch [-] and [+] to specify the
adjustment amount.
– To cancel the shift, touch [No Shift].
C451
7
7-84