Konica Minolta bizhub C451 User Manual page 224

Additional copy operations
6
Touch [Change Setting] in the screen that appeared when the proof
copy was printed.
– To stop copying while the proof copy screen is displayed, press the
[Reset] key or the [C] (clear) key. Otherwise, select the proof copy
job to be stopped from the list of jobs in the left panel, and then
touch [Delete]. In the screen that appears, requesting confirmation
to delete the job, touch [Yes], and then touch [OK].
– If no operation is performed within the specified length of time while
this screen is displayed, the copy job being proofed is registered as
a stored job and the Basic screen appears again. Jobs are regis-
tered as stored jobs under the following conditions.
When the automatic system reset operation is performed
After one minute (when "System Auto Reset" is set to "OFF")
For details on stored jobs, refer to page 10-15. If "System Auto Re-
set" is set to "OFF", the job is stored if no operation is performed
for 1 minute.
– For details on the automatic system reset operation, refer to "Auto-
matically cancelling the mode screen (System Auto Reset)" on
page 1-41.
– The number under "Number of Sets" in the screen that appeared
when a proof copy is printed indicates the number of sets printed
as proof copies/total Number of Sets specified.
– The number under "Total # of Pages Printed" in the screen that ap-
peared when a proof copy is printed indicates the number of copies
printed as proof copies/the number of pages printed in the proof
copy.
7
In the screen allowing you to change the settings, change the copy set-
tings as desired, and then touch [OK].
– If the copy settings cannot be changed, stop printing the proof
copy. Next, press the [Reset] key to cancel the copy settings, and
then specify the desired settings.
C451
3
3-7