Table of Contents
Advertisement
BASIC FUNCTIONS
This saw has been designed for cutting solid wood as well as manufactured wood materials such as plywood, wood
panelling, particleboard, mdf and other wood based by-products. This saw is not designed for cutting metals nor
for cutting any materials other than wood or wood based stock.
This saw is designed for use with maximum 10" (250mm) diameter blades having a center hole diameter of 5/8".
The blade can be raised to cut a maximum stock thickness of 3" with the blade set 90 degrees to the table. The
blade can be tilted up to 45 degrees to the left for bevel cuts to a maximum stock thickness of 2 1/4". Using any
standard aftermarket 8" diameter stacked dado blade set (not included), the maximum dado cutting capacity of
this saw is 13/16" (21 mm).
Note: for safer dado cutting, an optional dado table insert (part number #50-202) can be purchased through your General
International distributor.
The 50-275R is supplied with both a riving style splitter/blade guard assembly and a European style riving knife that
are both designed to raise or lower and tilt with the blade, and maintain a consistent distance to the blade at all
times, regardless of the height or angle of the blade. This can help reduce (but not totally eliminate) the risk of a
kickback incident, where the workpiece is thrown back at the operator, by helping to prevent the workpiece from
getting stuck between the blade and the riving style splitter or riving knife (as compared to a traditional stationary
splitter) or from closing up on the back of the blade as it passes through the cut.
UNPACKING
Carefully unpack and remove the saw and its compo-
nents from the box and check for damaged or missing
items as per the list of contents below.
NOTE: Please report any damaged or missing items to your
General® International distributor immediately.
LIST OF CONTENTS
A - SAW .................................................................................................1
HANDWHEEL WITH LOCK KNOB .....................................................2
B -
C - TABLE EXTENSION ............................................................................2
D - 17 MM HEX HEAD BOLT W/WASHER...............................................6
EUROPEEN STYLE RIVING KNIFE ......................................................1
E -
COMBINATION RIVING STYLE SPLITTER & BLADE GUARD..............1
F -
G - MITER GAUGE ..................................................................................1
H - PHILLIPS HEAD SCREW.....................................................................8
I -
14-17 MM OPEN END WRENCH......................................................1
10-12 MM OPEN END WRENCH......................................................1
J -
ARBOR WRENCH..............................................................................1
K -
MITER GAUGE/RIP FENCE STORAGE BRACKET ..............................3
L -
M - ARBOR WRENCH STORAGE BRACKET.............................................1
N - ALLEN KEY (6-4-3 MM,1 EACH).......................................................3
O - SCREW, NUT AND WASHER FOR SWITCH PLATE ..............................2
PLATE WITH MAGNETIC SAFETY SWITCH .........................................1
P -
Q - FRONT RAIL * ....................................................................................1
REAR RAIL (TWO PARTS) * ................................................................1
R -
FENCE * ............................................................................................1
S -
FENCE AND RAIL HARDWARE BAG * ...............................................1
T -
NOTE: EXF-30S rip fence and EXR-50 guide rails are packaged
separately.
ADDITIONAL REQUIREMENTS FOR SET UP
• Extra person for help with lifting
• Phillips Screwdriver
• Straightedge
• Machinist square or triangle square
8
QTY
or
A
B
E
F
H
I
J
K
O
FENCE & RAILS (packaged separately)
*
R
*
T
C
D
G
L
M
N
P
*
Q
*
S
Hide quick links:
Advertisement
Table of Contents
