Table of Contents
Advertisement
ASSEMBLY INSTRUCTIONS
SERIOUS PERSONAL INJURY COULD OCCUR IF YOU CONNECT THE MACHINE TO THE POWER SOURCE BEFORE YOU HAVE
COMPLETED THE INSTALLATION AND ASSEMBLY STEPS. DO NOT CONNECT THE MACHINE TO THE POWER SOURCE UNTIL
INSTRUCTED TO DO SO.
INSTALL THE TABLE EXTENSION WINGS
Attach the table extension wings to the main table
using 6 hex head bolts (3 per wing) and 6 lock wash-
ers A. Align the table extensions with the table and
loosely attach the bolts. Place a straightedge on the
table and extension as shown to align the extension
table B and then tighten down the bolts.
Note: Be sure that the table extension wings are flush with
C
front edge of table
.
INSTALL THE HANDWHEELS
1.
Install one handwheel onto the shaft at the front of the
saw as shown in A.
Note: The slots in the handwheel must be aligned with the
spring pin on the shaft.
2.
Thread a lock knob B into the handwheel shaft to
secure the handwheel in place.
3.
Repeat with the second handwheel, on the shaft loca-
ted on the right side of the saw cabinet, C.
MOUNT THE RIP FENCE STORAGE BRACKETS
B
Install the fence storage brackets A (the two larger
ones) on the left side of the saw as shown in B, using 4
Phillips head screws C.
MOUNT THE SWITCH
A
10
A
MOUNT THE MITER GAUGE & ARBOR WRENCH STORAGE BRACKETS
C
A
C
Install the miter gauge storage bracket A (the smaller
one) and arbor wrench storage bracket B on the right
side of the saw as shown in C, using 2 Phillips head
screws D per bracket.
level here
flush here
A
B
A
Make sure the magnetic safety
B
switch is well fixed to the switch
plate A and then fix the switch
plate to the left extension wing
of the table B with a 12 mm
wrench.
B
C
C
B
D
Hide quick links:
Advertisement
Table of Contents
