Attach The Rear Fence Rail To Your Saw; Install / Remove A Saw Blade; Install A Saw Blade - General International 50-275R Setup & Operation Manual

ATTACH THE REAR FENCE RAIL TO YOUR SAW

B
1. Use two cap screws with lock washers and flat washers to attach the rear rails to the table A. Use two
cap screws with lock washers, flat washers and nuts to attach the rails to the extension wings B.
C
2. Make sure that the intersection C between the two rear rails is leveled D.

INSTALL / REMOVE A SAW BLADE

Note: This saw is intended for use with 10" (250mm) diameter or less saw blades having a center hole diame-
ter of 5/8". There are many types of blades available to perform specific cutting jobs, such as crosscuts or rip-
ping only, or for use with plywood, panelling and other products. A good quality specialty blade can produce
a finer finish, be more efficient and place less strain on the saw. Use only saw blades designed for use at a
maximum operating speed of 5000 RPM or less. Saw blades should be kept clean and sharp. Never store saw
blades by stacking them directly in contact with each other. Place a layer of cardboard or similar material
between the blades to keep them from coming into contact with each other.
BE SURE THE SAW IS UNPLUGGED AND COMPLETELY DISCONNECTED FROM THE POWER SOURCE WHENEVER INSTALLING
OR REMOVING A SAW BLADE!

INSTALL A SAW BLADE

A
1. Remove the table insert plate A. Then, remove the
arbor nut B & flange C.
12
A
D
D
FRONT
C
B
2. Install a saw blade on the arbor so that the open-
ings between the teeth face the front of the saw
D (the blade spins in the counter-clockwise direction).
A
B
BLADE
DIRECTION