Basic Functions Of The Unit; Placement Within The Shop / Establishing A; Placement Within The Shop; Establishing A Safety Zone - General International 90-140 M1 Setup & Operation Manual

BASIC FUNCTIONS OF THE UNIT

This 14" wood cutting bandsaw is supplied with a 3/8" wide
general purpose blade and is designed to accommodate
blade widths from 1/4" to 3/4". Ideal blade length for this 90-
140 M1 model is 93 1/2" (2375 mm).
Note: Generally speaking, because the upper wheel height is
somewhat adjustable (to allow for blade tensioning), a blade
length variation of plus or minus 1/2" from the "ideal blade
length" can be accommodated.
Maximum inboard width of cut (space between the blade
and the body of the saw A) is 13 1/2".
For cutting thicker stock or for resawing, the maximum
depth of cut B (or max. workpiece height) is 6" (up to 12"
with optional "riser block kit" item #90-130A – Refer to section
"Recommended Optional Accessories for your Bandsaw".
PLACEMENT WITHIN THE SHOP / ESTABLISHING A SAFETY ZONE
THIS MODEL 90-140 M1 BANDSAW IS HEAVY (191 LBS - 87 KG). DO NOT OVER-EXERT. THE HELP OF AN ASSISTANT
WILL BE NEEDED FOR THE FOLLOWING STEP .

PLACEMENT WITHIN THE SHOP

This machine should be installed and operated only on a
solid, flat and stable floor that is able to support the weight
of the bandsaw 191 LBS (87 kg) and the operator. Using the
dimensions shown as a guideline, plan for placement with-
in your shop that will allow the operator to work unencum-
bered and unobstructed by foot traffic (either passing shop
visitors or other shop workers) or other tools or machinery.

ESTABLISHING A SAFETY ZONE

For shops with frequent visitors or multiple operators, it is
advisable to establish a Safety Zone around shop machin-
ery. A clearly defined "no-go" zone on the floor around
each machine can help avoid accidents that could cause
injury to either the operator or the shop visitor. It is advisable
to take a few moments to either paint (using non-slip paint)
or using tape, define on the floor the limits or perimeter of each machines safety zone. Take steps to ensure that all
operators and shop visitors are aware that these areas are off limits whenever a machine is running for everyone
but the individual operating the unit.

CLEAN UP

The protective coating on the saw table prevents rust
from forming during shipping and storage. Remove it by
rubbing with a rag dipped in kerosene, mineral sprits or
paint thinner. (Dispose of potentially flammable solvent-
soaked rags according to manufacturer's safety recom-
mendations.)
A putty knife, held flat to avoid scratching the surface,
may also be used to scrape off the coating followed by
clean-up with solvent. Avoid rubbing the saw's painted
surfaces, as many solvent-based products will remove
paint.
To prevent rust, apply a light coating of paste wax or use
regular applications of any after-market surface protec-
tant or rust inhibitor.
A
66"
Tip: With a screw driver, push a solvent-saturated rag into
the T-slot to remove the grease so the miter gauge will
slide freely.
B
16"
27"
9