ADJUSTING THE BEVEL ANGLE POINTER
The bevel pointer should read "0" when the blade is at 90° to the table. If not, with the blade set 90° vertical to the
table, proceed as follows:
1.
Remove the handwheel by loosening the hand
wheel lock knob A.
Notes
20
A
2.
C
B
Once the handwheel has been removed, loosen
the Phillips head screw B on the pointer mounting
bracket with a screwdriver and manually align the
pointer C with the zero on the bevel scale, then re-
tighten the screw and re-attach the handwheel.