Config Ipif System - D-Link DGS-1210-10P Reference Manual

6 Command Line Interface
Parameters
Restrictions
Example usage:
To upload a firmware file:
DGS-1210-52>upload firmware_toT F T P 1.1.1.23 1\running—c onfig
01–J an–2000 01: 26: 11 %C O P Y –I–F IL E C P Y :
running–c onfig des tination UR L tftp: //1.1.1.23/1\running–c onfig
.....01–J an–2000 01: 26: 16 %C O P Y –W –T R AP :
c ompleted s uc c es s fully
!
158 bytes c opied in 00: 00: 05 [hh: mm: s s ]
DGS-1210-52>

config ipif system

Purpose
Syntax
Description
Parameters
Restrictions
Example usage:
To configure the IP interface System:
DGS-1210-52> c onfig ipif S ys tem ipaddres s 10.48.74.122/8
S uc c es s .
firmware_toTFTP − Upload the firmware on the Switch from a
TFTP server.
cfg_toTFTP − Specifies that the Switch's current settings will be
uploaded to the TFTP server.
<ipaddr> − The IPv4 address of the TFTP server.
<ipv6addr> − The IPv6 address of the TFTP server.
<path_filename> − The filename of the firmware or switch
configuration file on the TFTP server. You need to specify the
DOS path if the file is not at the root directory of the TFTP server.
None.
To configure the System IP interface.
config ipif system { ipaddress <ip-address> <subnet-mask>
gateway <gw-address> | dhcp | bootp }
The c onfig ipif s ys tem command configures the System IP
interface on the Switch.
ipaddress <ip-address> <subnet-mask> − The IP address and
subnet mask to be created. Users need to specify the address
and mask information
example,10.1.2.3/255.0.0.0)
gateway <gw-address> − The IP address of the router or
gateway.
dhcp − Allows the selection of the DHCP protocol for the
assignment of an IP address to the Switch's System IP interface.
bootp − Allows the selection of the BOOTP to the switch.
None.
92
D-Link Web Smart Switch User Manual
F iles C opy – s ourc e UR L
T he c opy operation was
using the traditional format (for