Hardware Installation; Step 1: Unpacking; Step 2: Switch Installation; Desktop Or Shelf Installation - D-Link SmartPro DGS-1500-20 User Manual

2 Hardware Installation

2
Hardware Installation
This chapter provides unpacking and installation information for the D-Link SmartPro Switch.

Step 1: Unpacking

Open the shipping carton and carefully unpack its contents. Please consult the packing list located in the
User Manual to make sure all items are present and undamaged. If any item is missing or damaged, please
contact your local D-Link reseller for replacement.
One D-Link SmartPro Switch
One AC power cord
Four rubber feet
Screws and two mounting brackets
One Multi-lingual Getting Started Guide
One CD with User Manual, SmartConsole Utility program, and D-View Module
If any item is found missing or damaged, please contact the local reseller for replacement.

Step 2: Switch Installation

For safe switch installation and operation, it is recommended that you:
Visually inspect the power cord to see that it is secured fully to the AC power connector.
Make sure that there is proper heat dissipation and adequate ventilation around the switch.
Do not place heavy objects on the switch.

Desktop or Shelf Installation

When installing the switch on a desktop or shelf, the rubber feet included with the device must be attached
on the bottom at each corner of the device's base. Allow enough ventilation space between the device and
the objects around it.

Rack Installation

The switch can be mounted in an EIA standard size 19-inch rack, which can be placed in a wiring closet with
other equipment. To install, attach the mounting brackets to the switch's side panels (one on each side) and
secure them with the screws provided (with 8 M3*6.0 size screws).
Then, use the screws provided with the equipment rack to mount the switch in the rack.
Figure 2.1 – Attach the adhesive rubber pads to the bottom
Figure 2.2 – Attach the mounting brackets to the Switch
5
5
D-Link Web Smart Switch User Manual