Front I/O assembly
The front I/O assembly is attached to the front of the chassis. Push the assembly into the chassis to remove.
1.
Prepare the computer for disassembly
2.
Remove the access panel
3.
Remove the front bezel
4.
Rotate the drive cage to its upright position.
5.
Disconnect the cables from the system board as follows:
●
(1) Yellow connector labeled FRONT_USB
●
(2) Blue connector labeled FRONT AUD
●
(3) Blue connector labeled FRONT_USB3.0
(Preparation for disassembly on page
(Access panel on page
(Front bezel on page
73).
73).
72).
Front I/O assembly 103