HP EliteDesk 705 G1 Desktop Mini Maintenance And Service Manual page 214

Control panel message
1720-SMART Hard Drive Detects Imminent
Failure
1796-SATA Cabling Error
2212-USB Key Provisioning failure writing to
device
2217-ME Firmware Version request failure
2218-ME Firmware Version should be updated
2219-USB Key Provisioning file has invalid
header identifier
2220-USB Key Provisioning file has mismatch
version
Invalid Electronic Serial Number
204 Chapter 9 POST error messages
Description
Hard drive is about to fail. (Some hard drives
have a hard drive firmware patch that will fix an
erroneous error message.)
One or more SATA devices are improperly
attached. For optimal performance, the SATA 0
and SATA 1 connectors must be used before
SATA 2 and SATA 3.
USB device used for USB key provisioning will
not allow BIOS to update provision file
properly.
ME firmware is not properly responding to BIOS
query for version information.
ME firmware must be updated to match current
functionality contained in the system BIOS.
Provisioning file contained on the USB key has
been corrupted or is not a valid version for the
current ME firmware.
Provisioning file contained on the USB key is
not a valid version for the current ME firmware.
Electronic serial number is missing.
Recommended action
1. Determine if hard drive is giving correct
error message. Run the Drive Protection
System test under using F2 Diagnostics
when booting the computer.
2. Apply hard drive firmware patch
if applicable. (Available at
http://www.hp.com/support.)
3. Back up contents and replace hard drive.
Ensure SATA connectors are used in ascending
order. For one device, use SATA 0. For two
devices, use SATA 0 and SATA 1. For three
devices, use SATA 0, SATA 1, and SATA 2.
1. Try a different USB key device for
provisioning.
2. If the error persists, update to the latest
BIOS version and ME firmware version.
3. If the error still persists, replace the
system board.
1. Reboot the computer.
2. If the error persists, update to the latest
BIOS version and ME firmware version.
3. If the error still persists, replace the
system board.
1. Update to the latest ME firmware version.
2. If the error persists and system BIOS has
been recently updated, restore previous
system BIOS version.
3. If the error still persists, replace the
system board.
1. Recreate the provisioning file using third
party management console software.
2. If the error persists and system BIOS has
been recently updated, restore previous
system BIOS version. Otherwise, update
the ME firmware version.
3. If the error still persists, replace the
system board.
1. Reboot the computer.
2. If the error persists and system BIOS has
been recently updated, restore previous
system BIOS version. Otherwise, update
the ME firmware version.
3. If the error still persists, replace the
system board.
Enter the correct serial number in Computer
Setup.