System board
NOTE:
All system board spare part kits include replacement thermal material.
NOTE:
System board appearance may vary.
Description
System board for use in models without Windows 8.1
System board for use in models with Windows 8.1 Standard
System board for use in models with Windows 8.1 Professional
System board for use in NetClone models
1.
Prepare the computer for disassembly
2.
Remove the access panel
3.
Remove the baffle
4.
Rotate the drive cage to its upright position.
5.
When replacing the system board, make sure the following components are removed from the defective
system board and installed on the replacement system board:
●
Memory modules
●
Expansion cards
●
Heat sink
●
Processor
6.
Remove the baffle from the chassis
7.
Disconnect all cables connected to the system board, noting their location for reinstallation.
8.
Remove the eight Torx T15 screws that secure the system board to the chassis.
116 Chapter 5 Removal and replacement procedures – small form factor (SFF) chassis
(Preparation for disassembly on page
(Access panel on page
(Baffle on page
101).
(Memory on page
(Expansion card on page
(Heat sink on page
109)
(Processor on page
112)
(Baffle on page
73).
78)
81)
101).
72).