Speaker
The speaker is attached to the front of the chassis under the rotating drive cage.
1.
Prepare the computer for disassembly
2.
Remove the access panel
3.
Remove the front bezel
4.
Rotate the drive cage to its upright position.
5.
From the outside, front of the chassis, remove the two Torx T15 screws that secure the speaker.
6.
From the inside of the chassis, disconnect the speaker cable from the white system board labeled SPKR
(1), and the remove the speaker from the chassis (2).
To install the speaker, reverse the removal procedures.
108 Chapter 5 Removal and replacement procedures – small form factor (SFF) chassis
(Preparation for disassembly on page
(Access panel on page
73).
(Front bezel on page
73).
72).