Programming Macro Buttons - Abus WIRELESS ALARM SYSTEM Operating Instructions Manual

Wireless
Hide thumbs Also See for WIRELESS ALARM SYSTEM:
Table of Contents

Advertisement

Programming macro buttons

6.6
With the ABUS wireless alarm system, you can assign longer commands to a single
button, a so-called macro button. If you then press the macro button and keep it pressed
for two seconds, the command you have programmed for it is executed. The macro
buttons A, B and C are subordinate to the buttons [1], [2] and [3].
Before programming a macro button, you should first execute the command "normally".
Important: Make a note of all buttons to be pressed and their sequence. You must
follow this sequence later when you program the macro buttons (see step 5 of
programming on the next page). You can program up to 3 macro buttons.
IMPORTANT:
Only the Grand Master can program macro buttons. No macro buttons can be
programmed for deactivating the system. You always need a user PIN for this!
To program a macro button:
1.
Under user functions, press [8] for Macro key.
2.
Enter the Grand Master PIN and press
3.
Three macro buttons [1/A, 2/B, 3/C] are listed. Select the macro button you
want to program and confirm with
4.
Keep the button you selected in the previous step pressed for two seconds.
5.
Now program the macro button:
Use the numeric buttons to enter the digits (0–9), and use the
program the macro button.
For example: To internally activate partitions 1 and 2 (in a system consisting of 3
partitions), you would normally enter the following:
[#]1 1234 E [#]2 1234 E
Everything you enter is shown in the second line
of the LCD display.
IMPORTANT:
When you save the macro, make sure the cursor follows the last character and is not
below it.
To enter characters (and digits):
38
buttons to select the characters (E, I, A, B, C) that you need to
.
.
and

Advertisement

Table of Contents
loading

This manual is also suitable for:

Fu9010

Table of Contents