Abus WIRELESS ALARM SYSTEM Operating Instructions Manual page 44

2 Activities
1 Operate utility output
2 Follow Me
3 Monitoring station
control
4 Delete Remote
Message
5 Anti-Code
6 Duress Restore
With the switch outputs, you control external
equipment via the ABUS wireless alarm
system (a motor-driven garage door, the
entrance lighting, etc. ).
You have two options:
[1] Defining the FM number:
You can define up to 4 FM numbers. In the
event of an alarm, the system will call the
defined numbers. For more details, see section
6.2.
[2] Stopping the FM number:
If you have defined more than one FM number,
you can prevent dialling of further numbers. Use
this option if an alarm is triggered but it is not
necessary to call further FM numbers.
1) FM Enable – This function starts a call to the
command centre.
2) Uebergabe??? – This function tests the
telephone connection.
3) U/D Enable – Enables remote dialling of the
up/download software by modem.
Delete a message sent by the U/D software to
the LCD display.
Enter the GM PIN to reset a duress alarm.
Deactivates a permanent switch output that was
activated by the input of a duress PIN.
41