Chapter 9 Appendix; Appendix A: System Troubles - Abus WIRELESS ALARM SYSTEM Operating Instructions Manual

Chapter 9 Appendix

Appendix A: System troubles

9.1
To search for system faults, press
troubles" is announced. This is followed by a list of current fault messages. If the fault
list is empty, you hear the message "No System troubles".
The following table describes system faults (with possible solutions).
Trouble Description
Main faults
Auxiliary failure The group output of the
alarm system, which is
used for supplying
assigned devices (e.g.
motion sensor) with
electricity, has failed.
Bell loop trouble The external sounder is
disconnected.
Clock not set The system clock shows
neither time nor date.
False code If programmed, your
trouble system displays the input
of an invalid PIN code as
a fault.
Loss of AC The power supply has
power failed. The system is
operated on standby
batteries as long as
possible.
Low battery The capacity of the
battery is low or the
battery is dead. It must be
recharged or replaced.
and . The opening message "System
LCD display Message
"Auxiliary failure"
"Bell loop trouble" Switch off all power
"Clock not set"
"False code
trouble"
(P=1 refers to the
partition for which
the invalid code
was entered.)
"AC loss"
"Low battery
trouble"
Solution
Switch off all power
to the system.
Check the
connection. Max.
load of output
200mA.
to the system and
check the sounder
connection.
Set the time and
date. See section
6.1.
If the fault was
displayed, it is
automatically reset
by the system.
Check the system
power supply. Make
sure that the power
supply is not
interrupted or
switched off.
Replace the battery
as described in
chapter 8.
47