Table of Contents
Advertisement
2.5
Installing SSDs
The server have two SSD bays with Hot-Swap support located at the rear panel. The SSD
bays allows you to install up to two 2.5-inch SSDs for additional data storage.
To install an SSD:
1.
Press the spring lock to release to
release the tray lever.
2.
Firmly hold the tray lever then pull the drive
tray out of the bay.
3.
Release the screws on each side of the
drive tray to release the drive tray metal
beam.
The drive tray metal beam provides
horizontal support to the empty drive
tray and prevents the drive tray from
being bent or deformed.
4.
Orient and place the SSD into the tray.
Ensure that the SSD is fitted firmly inside
the drive tray and that the four screws of
the SSD matches the four screw holes of
the drive tray.
2-14
metal beam
SSD screw hole
SSD
drive tray screw hole
spring lock
tray lever
Chapter 2: Hardware setup
Advertisement
Table of Contents
