Table of Contents
Advertisement
The Create New Volume screen shows the disks you can add to make up the RAID
3.
1E/10 volume.
RAID 1E/10 supports three to ten disks, or, seven mirrored disks plus two hot spare
disks. Use the arrow key to select a disk, then move the cursor to the RAID Disk
column. To include this disk in the array, press <+>, <->, or <Space>.
LSI Corp Config Utility
Create New Volume -- SAS2308-2
Volume Type:
Volume Size(GB):
Slot
Num
0
1
2
3
Esc = Exit Menu
SPACE/+/- = Select disk for volume
By default, the RAID Disk field shows No before volume creation. This field is grayed out
under the following conditions:
•
•
•
4.
Repeat step 3 to add the other disks to the volume.
When done, press <C> to create the volume then select Save changes then exit this
5.
menu.
Create and save new volume?
Cancel Exit
Save changes then exit this menu
Discard changes then exit this menu
Exit the Configuration Utility and Reboot
6.
Wait for the utility to finish creating the volume.
LSI Corp Config Utility
Create New Volume -- SAS2308-2
Processing...may take up to 1 minute
Creating RAID Volume...
6-24
Device Identifier
ATA
WDC WD800JD-22LS1D06
ATA
WDC WD800JD-22LS1D06
ATA
WDC WD800JD-22LS1D06
ATA
WDC WD800JD-22LS1D06
F1/Shift+1 = Help
The disk does not meet the minimum requirements for use in a RAID volume.
The disk is not large enough to mirror existing data on the primary drive.
The disk is already part of another volume.
v7.29.00.00 (2012.11.12)
RAID 1E
-------
RAID
Drive
Disk
Status
[No]
----------
[No]
----------
[No]
----------
[No]
----------
C = Create volume
v7.29.00.00 (2012.11.12)
Chapter 6: RAID configuration
Pred
Size
Fail
(GB)
No
No
No
No
Advertisement
Table of Contents
