Failure During Pod Deactivation; Figure - Insulet OmniPod User Manual

11
Communication Failures
3. If at any point in this process the PDM can communicate
again with the pod, you will see either:
a. Figure 11-5, indicating that your original instruction or
command was successfully sent to the pod. When you
press OK, or within 5 seconds, the System displays the next
screen in the command sequence you were entering.
b. Figure 11-6, indicating that your original command was
not sent to the pod. Press OK. If you were activating a pod,
the System returns to the previous screen, where you can
continue activation. If you were issuing any other com-
mand, the System returns to the Status screen, where
you can reissue the command.

Figure 11-5

124
Figure 11-6
Home
■

Failure During Pod Deactivation

To review the deactivation process, see "Deactivate the current
OmniPod" in Chapter 5, Using the OmniPod.
If you press Confirm to deactivate the current pod and the PDM
cannot send your instruction to the pod, you will see the screen
in Figure 11-7.
Figure 11-7
Either:
1. Press Retry to try deactivating the pod again. If the PDM still
cannot send the instruction, you will see Figure 11-7 again.
Follow step 2.
2. Press Discard. The PDM will consider the pod lost, and ask
whether you want to activate a new pod.
Food Library Power/Backlight