Infopia Eclipse Manual page 17

Before You Test
Code numbers are used to calibrate the
Test strips for accurate results. You must code the meter
before using it. Confirm the code number for the first test and then every
time you change to a new vial of test strips.
18
Insert the test strip to turn your meter on. Please
insert your test strip fully, but be careful not to bend. The code
number should appear in the LCD window for 3
seconds (example: C18). Compare the code number on the
meter's LCD window with the code number on the test strip
vial. If the two code numbers match, you can start testing.
If the two code numbers do NOT match, you must code
your meter according to the test strip vial code number before
the LCD display ends(Within 3 Seconds). Press the
button to select the correct code. The number increases or
decrease by one digit every time you press
To move more quickly, press and hold
If any error message appears any time, please refer to the
Trouble Shooting section of the manual for more
information (please refer to page 31-34).
Meter with the
or
or buttons.
or
button.