Chapter 3 Initial Setup; Inserting A Compactflash Card; Connecting Power - Advantech UNO-3072LA User Manual

Chapter 3 Initial Setup

3.1 Inserting a CompactFlash Card

UNO-3072LA provides two CompactFlash slots. One slot (CF2) on the
daughterboard is accessible from the top of the system, where you can
insert your CompactFlash card directly. The other slot (CF1) is inside
UNO-3072LA on its motherboard. You can set SW3-1 to decide which
one is the master.
SW3-1 on motherboard (refer to Figure A.4)
OFF: External CF (CF2) master, Internal CF (CF1) Slave
ON: External CF (CF2) Slave, Internal CF (CF1) Master
Note: Only one CompactFlash can be set as master
Internal & external CompactFlash doesn't support Hot Swap
Needs to use " Fixed Disk Mode" CompactFlash to install OS
Following is the procedure for the installing a CompactFlash card in the
internal slot of your UNO-3072LA. Please follow these steps carefully:
1. Remove the power cord.
2. Unscrew the four screws from the top cover of UNO-3072LA.
3. Remove the top cover.
4. Plug a CompactFlash card with your OS and application program
into a CompactFlash card slot on mainboard.
5. Screw back the top cover with four screws.

3.2 Connecting Power

Connect the UNO-3072LA to a 9 ~ 36 VDC power source. The power
source can either be from a power adapter or an in-house power source.
UNO-3072LA User Manual 24