Response SA1 Installation & Operating Manual page 21

TROUBLE SHOOTING - continued
/
Symptom Recommendation
Magnetic Contact Detector not working.
1. Ensure batteries are connected with correct polarity.
2. Ensure battery connections are good.
3. Ensure 'House Code' is the same as Solar Siren.
4. Ensure DIP switches 9 and 10 are set correctly.
5. If no external contacts are connected ensure jumper
link fitted.
6. If external contacts are connected:
a. Ensure jumper link removed.
b. Check that all contacts are closed.
c. Check all contacts are wired in series.
IF YOU HAVE ANY PROBLEMS
RING THE HELPLINE:
Important In order to comply with the Code of Practice on Noise from Intruder Alarms 1981 you should carry
out the following procedures within 48 hours of Intruder Alarm installation.
notice
following 1. Notify your local police station in writing that an Intruder Alarm System has been installed, giving
alarm
installation:
2. Inform the Local Environmental Health Authority of the installation and which police station has
3. Ensure that all users are aware of the operating procedures.
4. Immediately inform your Local Authority and police station if there is a change to the persons
SA1/SA2/SAC1
01268 563273
names and contact details of at least two persons who have a Remote Control or know the
User Access code for the Keypad.
been informed.
who have Remote Controls.
/
Symptom Recommendation
Magnetic Contact Detector false alarming.
1. Ensure that gap between magnet and detector is
less than 10mm.
2. Tamper switch below battery cover not depressed -
check battery cover is fitted correctly and that fixing
lugs are not broken.
LED on Magnetic Contact Detector
illuminating when door or window is opened.
1. Low battery - replace Batteries.
(Lines open 9.00am
to 5.00pm, Monday
to Friday.
19