Foglights With The Corner Function; Rear Fog Light; Tourist Lights; Fig - Skoda Roomster Owner's Manual

Foglights with the CORNER function


Read and observe on page 59 first.
The CORNER function lights the front fog lamp on the relevant side of the ve-
hicle to illuminate the area around the vehicle when turning, parking, etc.
The CORNER function is switched on automatically if the following conditions
are met.
›
The turn signal is switched on or the front wheels are turned sharply to the
right or left .
1)
›
The engine is running.
›
The vehicle is stopped or moves at a speed of no more than 40 km/h.
›
The low beam is switched on.
›
The daytime running lights are not switched on.
›
The fog lights are not switched on.
›
Reverse gear is not engaged.

Rear fog light


Read and observe on page 59 first.
Switching on/off
›
First turn the light switch » Fig. 43
›
Pull the light switch to position
The rear fog light is switched off in the reverse sequence.
If the vehicle is not fitted with fog lights, the rear fog light is switched on by
pulling out the light switch directly to the only possible setting.
The warning light lights up in the instrument cluster when the rear fog light

is switched on » page 39.
Only the rear fog light on the trailer lights up if the vehicle has a factory-fitted
towing device or a towing device from ŠKODA original accessories and it is
driven with a trailer.
1) If both switch on versions are conflicting, for example if the steering wheel is turned to the left and the
right turn signal light is switched on, the turn signal light has the higher priority.
62
Operation
on page 61 to position  or .
.
2

Tourist lights


Read and observe on page 59 first.
Halogen projector headlights with cornering light function
This mode makes it possible to drive in countries with opposing traffic system
(driving on the left/right) without dazzling the oncoming vehicles. When the
mode "tourist light" is active, the side to side swivel of the headlights is deacti-
vated.
Activating tourist light
Before activating the tourist light, the following conditions must be met.
Ignition switched off, light switched off (light switch in position 0), control dial
for headlamp beam adjustment in the  position, no gear engaged or selector
lever in the N position (automatic gearbox), tourist light deactivated.
›
Switch on the ignition.
Within 10 seconds of the ignition being switched on:
›
Turn the light switch to the  position
›
Engage reverse gear (manual gearbox) or move the selector lever to the R
position (automatic gearbox),
›
Turn the headlamp beam adjustment dial from  to 
Deactivating tourist light
Before deactivating the tourist light, the following conditions must be met.
Ignition switched off, light switched off (light switch in position 0), control dial
for headlamp beam adjustment in the  position, no gear engaged or selector
lever in the N position (automatic gearbox), tourist light activated.
›
Switch on the ignition.
Within 10 seconds of the ignition being switched on:
›
Turn the light switch to the  position
›
Engage reverse gear (manual gearbox) or move the selector lever to the R
position (automatic gearbox),
›
Turn the headlamp beam adjustment dial from  to 
Further information » page 118, Headlights.
» page 59, Switching the light on/off.
» page 60.
» page 59, Switching the light on/off.
» page 60.
