›
Undo and remove a bolt
» Fig. 96
one bolt
» Fig. 96
- in the lower area.
›
Move the safety partition into the required position. Ensure it is always move
the same distance- the same number of holes on both sides both upwards
and downwards.
›
On each side in the upper area of the body, undo and remove a bolt and undo
and remove a bolt in the lower area.
›
Have the tightening torque of the bolts checked with a torque wrench as
soon as possible. The tightening torque must be 20 Nm.
›
Change the position of the cover of the luggage compartment floor behind
the safety partition so that it lines up with the new position of the safety
partition.
›
Fold back the loading floor part.
Emergency release of the loading area door
Read and observe
on page 87 first.
If there is a fault in the central locking, you can unlock the loading area door as
follows:
›
Pull the control cable towards you and pull on it.
›
Press on the loading area door to open it.
›
Press the control cable back again.
- on either side in the upper body and
Fig. 97
Emergency unlocking of the
loading area door
Interior lighting
Read and observe
on page 87 first.
Switching on
›
Move the cover glass to the position
Switching off
›
Move the cover glass to the O
» Fig. 98
Door contact setting
›
Move the cover glass to the middle position
Note
We recommend you have the bulb replacement performed by a specialist ga-
rage.
Fig. 98
Interior lighting
» Fig.
98.
position.
» Fig.
98.
Seats and stowing
89