Operation
Read and observe
on page 33 first.
The Toggle button for selecting menu items
found on the wiper stalk.
Select menu items
›
Briefly press the top or bottom of rocker switch
individual menu items in the multifunction display one after the other.
Select memory
›
Press button
» Fig.
23.
B
Reset memory
›
Select the desired memory.
›
Press and hold button
» Fig.
B
The following values from the memory selected will be set to zero by button
.
B
›
Average fuel consumption.
›
Distance driven.
›
Average speed.
›
Driving time
1)
This information is always shown on vehicles with a MAXI DOT display.
2)
This is not the case on the MAXI DOT display.
3)
On some models in certain countries, the display appears in kilometres/litre.
4)
On some models in certain countries, the display appears in --,- kilometres/litres if the vehicle is station-
ary.
34
Operation
Fig. 23
Multifunction display: Control el-
ements
» Fig. 23
and button
A
» Fig.
23. This opens the
A
23.
Multifunction display details
Read and observe
Outside temperature
The current outside temperature is displayed
The temperature is shown with the snowflake symbol if the outside temper-
ature is below +4 °C.
This display flashes for a few seconds, then shows the most recently displayed
function
.
2)
If the temperature drops below +4 °C while the car is driving at a speed faster
than 10 km / h, a beep is also heard.
Driving time
are
B
The driving time elapsed since the memory was last erased appears in the dis-
play. Reset the memory to zero by pressing the button
measure the driving time from a particular moment.
The maximum time indicated in both memories is 19 hours and 59 minutes and
on vehicles which are fitted with a MAXI DOT display, it is 99 hours and 59 mi-
nutes. The indicator is set back to zero when this period is exceeded.
Current fuel consumption
The current fuel consumption level is displayed in litres/100 km
this information to adapt your driving style to the desired fuel consumption.
The display appears in litres/hour if the vehicle is stationary or driving at a low
speed
.
4)
Average fuel consumption
The average fuel consumption since the memory was last erased is displayed
in litres/100 km
.
3)
Set the memory to zero at the start of a new measurement if you wish to de-
termine the average fuel consumption over a certain period
tion. No value will appear in the display after it has been erased until you have
driven approximately 300 m.
on page 33 first.
.
1)
» page
34, Operation to
. You can use
3)
» page
34, Opera-