Skoda Roomster Owner's Manual page 125

Switching off temporarily
Switching off completely
The Cruise Control System (CCS) maintains a set speed, more than 25 km/h,
without you having to actuate the accelerator pedal.
This is only possible within the range which is permitted by the power output
and braking power of the engine.
The warning light in the instrument cluster lights up when the cruise con-

trol system is switched on.
WARNING
For safety reasons, the cruise control system must not be used in dense
■
traffic or on unfavourable road surfaces (such as icy roads, slippery roads,
loose gravel) – there is a risk of an accident.
The saved speed may only be resumed if it is not too high for the current
■
traffic conditions.
Always deactivate the cruise control system after use to prevent the sys-
■
tem being switched on unintentionally.
CAUTION
The cruise control system is not able to maintain a constant speed when
■
driving in areas with steeper gradients. The weight of the vehicle increases the
speed at which it travels. Therefore, shift to a lower gear in good time or slow
the vehicle down by applying the foot brake.
It is not possible to switch on the cruise control system on vehicles fitted
■
with a manual gearbox if the first gear or reverse gear is engaged.
On vehicles fitted with an automatic gearbox, it is not possible to switch on
■
the cruise control system if the selector lever is in position P, N or R.
The Cruise Control System may automatically switch off when some brake
■
assist systems (e.g. ESC) intervene, when the speed exceeds maximum permis-
sible engine speed, or a similar event takes place.
122
Driving
123
Storing a speed
123

Read and observe
Storing a speed
›
Press switch » Fig. 119
A
›
After the desired speed has been reached, press the rocker button
the SET position.
After you have released the rocker button
speed you have just stored is maintained at a constant speed without having
to depress the accelerator.
Changing a stored speed

Read and observe
Increasing the speed with the accelerator
›
Depress the accelerator to increase the speed.
›
Release the accelerator to reduce the speed back down to the preset speed.
However, if the saved speed is exceeded by more than 10 km/h for a period of
more than 5 minutes by depressing the accelerator, the stored speed is de-
leted from the memory. You have to re-store the desired speed.
Increasing the speed with the rocker button
›
Press rocker button
B
›
The speed will increase continuously, if the rocker button is pressed and held
in the RES position. Release the rocker button once the desired speed is
reached. The set speed is then stored in the memory.
Decreasing the speed
›
The stored speed can be reduced by pressing rocker button
page 122 to the SET position.
Fig. 119
Operating lever: Operating the
cruise control system
and on page 122 first.
to the ON position.
out of the position SET, the
B
and on page 122 first.
B
» Fig. 119 on page 122 to the RES position.
into
B
» Fig. 119 on
B
