Fig; Pull The Lever 1 » Fig - Skoda Roomster Owner's Manual

Safety pushbutton
The buttons for power windows in the rear doors can be deactivated by press-
ing the safety switch » Fig. 38. The buttons for the electrical power win-
S
dows in rear doors are activated again by pressing the safety pushbutton
again.
If the buttons for the rear doors are deactivated, the warning light  in the
safety switch lights up.
S
Note
The window lift mechanism is equipped with protection against overheating.
Repeated opening and closing of the window can cause this mechanism to
overheat. If this happens, it will not be possible to operate the window for a
short time. You will be able to operate the window again as soon as the over-
heating protection has cooled down.
Power window force limiter

Read and observe and
The electrical power windows are fitted with a force limiter. It reduces the risk
of bruises or injuries when closing the windows.
If there is an obstacle, the closing process is stopped and the window goes
down by several centimetres.
If the obstacle prevents the window from being closed during the next 10 sec-
onds, the closing process is interrupted once again and the window goes down
by several centimetres.
If you attempt to close the window again within 10 seconds of the window be-
ing moved down for the second time, even though the obstacle was not yet
been removed, the closing process is only stopped. During this time it is not
possible to automatically close the window. The force limiter is still switched
on.
The force limiter is only switched off if you attempt to close the window again
within the next 10 seconds - the window will now close with full force!
If you wait longer than 10 seconds, the force limiter is switched on again.
on page 56 first.
Window convenience operation

Read and observe
S
The convenience operation of the windows offers the possibility of opening or
closing all the windows at once.
Convenience operation can take place in one of the following ways.
Opening
›
Press the  symbol button on the remote control key and hold.
›
Hold the key in unlock position in the driver's door lock.
›
Hold button » Fig. 38
A
Closing
›
Press the  symbol button on the remote control key and hold.
›
Hold the key in the lock position in the driver's door lock.
›
Hold button » Fig. 38
A
The movement of the window is stopped immediately when the key or the re-
spective button is released.
Operational faults

Read and observe
Electrical power windows do not operate
If the battery has been disconnected and then reconnected while the window
was opened, the electrical power windows will not operate. The system must
be activated. Proceed as follows to re-establish the function.
›
Switch on the ignition.
›
Pull the top edge of the button in the driver's door and close the window.
›
Release the button.
›
Pull the relevant button upwards again for another approximately 3 seconds
and hold.
Operation in winter
In the winter, ice accumulating on the surface of the window may cause there
to be more resistance when closing the window. The window will stop and
move back several centimetres.
It is necessary to deactivate the force limiter to close the window
and on page 56 first.
on page 56 in the opening position.
on page 56 in the closing position.
and on page 56 first.
Unlocking and locking
» page 57.
57