Approved Tyre / Rim Combinations - Skoda Roomster Owner's Manual

CAUTION
Use the pressure of your hand only, do not strike the full wheel trim! The
■
cover could be damaged.
When using the anti-theft wheel bolt, ensure that it is in the hole in the
■
valve area.
If wheel trims are fitted, an adequate flow of air must be assured in order to
■
cool the brake system.
Note
We recommend that you use child seats from ŠKODA Original Accessories.
Wheel bolts

Read and observe and
Before removing the wheel bolts, remove the covering caps.
Pulling off
›
Push the extraction pliers » page 166
inner catches of the pliers are positioned at the collar of the cap.
›
Remove the cap in the direction of the arrow
Fitting
›
Push the cap onto the wheel bolt up to the stop.

Approved tyre / rim combinations


Introduction
This chapter contains information on the following subjects:
Explanation of the tyre labelling
Roomster
160
General Maintenance
Fig. 144
Remove the cap
on page 156 first.
sufficiently far onto the cap until the
» Fig. 144.
Roomster GreenLine
Roomster Green tec
Roomster Scout
Roomster Noire
Roomster N1
Roomster Praktik
This chapter contains manufacturer-approved tyre / rim combinations, divided
into modules according to the individual model variants.
Shared combinations are initially to be sought for the model variant (Roomster
GreenLine, Roomster Scout and such like) and then according to the engine
size of your vehicle.
If the model variant of your vehicle cannot be found in the discrete module,
then the approved combinations are to be found according to the engine size
of your vehicle in module
Only use radial tyres of the same type, size (rolling circumference) and tread
pattern on one axle on all four wheels.
When mounting new tires the tires have to be replaced axle by axle.
The information listed in the table corresponds to the information available at
the time of going to press.
The approved tyre / rim combinations for your car are given on the sales and
technical vehicle documentation.
Explanation of the tyre labelling
Explanation of tyre markings
For example, 185/65 R 14 86 T means:
185 Tyre width in mm
65 Height/width ratio in %
R Code letter for the type of tyre – Radial
14 Diameter of wheel in inches
86 Load index
T Speed symbol
The date of manufacture is stated on the tyre wall (possibly on the inside).
160
For example, DOT ... 11 14... means, for example, that the tyre was manufac-
161 tured in the 11th week of the year 2014.
» page 161, Roomster.
161
162
162
162
162
163
