Automatic Technology SECURALIFT Installation Instructions And Owner's Manual page 14

STEP 17.3 STORING TRANSMITTER CODE TO
OPERATE THE COURTESY LIGHT
The Transmitter can be programmed to operate the
Courtesy Light on the Door Opener.
1. Press and hold Light Code button 1 on the Control
Panel (FIG. 20).
2. Press the button on the Transmitter you would like
to use to control the light for approximately two
seconds, Pause for two seconds. Press the same
button again on the Transmitter for approximately
two seconds.
3. Release the Light Code button 1.
4. Press the Transmitter button to see if it operates
the light.
STEP 18 DELETING PROGRAMMED CODES
18.1 DELETING A STORED TRANSMITTER
CODE
1. Select the transmitter you want to delete.
2. Press and hold the blue Door Code button 2
(FIG. 21) on the Control Panel.
3. Press the Transmitter button you would like to
delete for two seconds. Pause for two seconds.
Press the Transmitter button again for two
seconds.
4. Release the blue Door Code button 2. The code
should now be deleted. Confirm this by pressing
the transmitter button to see if it can operate the
door. The door should not respond.
18.2 DELETING ALL STORED TRANMITTER
CODES
1. Turn the Power Off to the Drive Unit.
2. Press and hold the blue Door Code button 2
(FIG. 18) on the Control panel.
3. Turn the Power On again, while holding the Blue
Door Code button until the Coding LED illum-
inates. Release the blue Door Code button 2. All
the stored codes including the Courtesy Light
Codes should now be deleted. Confirm this by
trying to operate the door by pressing one of the
deleted transmitters.
STEP 19 SETTING OF COURTESY LIGHT
TIME
The preset courtesy light time on the Door Opener is
3 minutes. This time can be changed as below.
1. Press in together and hold the Auto Close Time
button 5 and Force Margin Set button 14. (FIG. 19)
2. While holding in the two buttons, press the green
Open button 11. (FIG. 19) Each press of this
button will add 10 seconds to the light time.
3. To decrease the time follow step 1 and press the
red Close button 3. (FIG. 19) Each press will deduct
10 seconds from the light time.
4. To recall the factory set default light time press in
and hold together the Auto Close Time button 5,
the Force Margin Set button 14 and the Reset
button 6 for about 2 seconds. (FIG. 22)
FIG. 19
FIG. 20
14