Table of Contents
Advertisement
7. Close the front cover. The toner cartridge carrier rotates to the next empty slot.
8. Repeat steps 1 through 7 until all cartridges are installed.
Notes:
•
The toner cartridge is installed securely when the lock lever cannot be turned further.
•
Although the toner is not harmful to your body, wash it off immediately if your hands or clothes are
stained with it.
•
The protective cover is attached to each toner cartridge slot at the factory. You only have to remove the
cover from each toner cartridge slot the first time that you install the toner.
•
When pulling out the seal, pull it out horizontally. The tape might break if it is pulled out diagonally.
•
After the seal has been pulled out, do not shake or bump the toner cartridge.
•
Make sure the toner cartridge is installed correctly. Otherwise, the front cover cannot close firmly.
3.7 Installing the drum cartridge
Warning
•
Never throw a drum cartridge into an open flame. It can cause an explosion and burn injuries.
1. When the [Load Drum Cartridge] message is displayed on the control panel, slowly flip back part B
until it stops.
2. Open the front cover, and then lift up the top cover.
3. Take the drum cartridge out of the packaging box, and then remove the protective sheet.
4. To insert the drum cartridge, push up the lever on the right side of the printer.
- 27 -
Advertisement
Table of Contents
