Table of Contents
Advertisement
3. Getting started
This chapter helps you get started using the DocuPrint C2090 FS.
3.1 Placing the DocuPrint C2090 FS
The DocuPrint C2090 FS should be located at a well-ventilated place so that the exhaust gases and heat
generated are not directly blown onto the user's face. Proper ventilation is necessary to prevent the machine
from overheating.
a
b
c
d
Important:
Ensure that the DocuPrint C2090 FS is installed at a location with the following conditions:
•
Temperature range 10-32° C, humidity range 15 - 85% (no condensation). Humidity should be 70% or
below at 32° C, and temperature should be 28° C or below at 85% humidity.
•
Do not expose the machine to direct sunlight.
•
Do not expose the machine to direct draft from an air-conditioner or heater.
Note:
•
When using the printer with the bypass tray opened, do not expose the printer to direct sunlight. Doing
so may cause a malfunction connecting power
3.1.1
Power cable
You can load the paper or install the toner cartridge and drum cartridge into the printer after the printer is
switched on.
Important:
•
The power cable does not support hot plug. Make sure the power switch is in off position before
connecting the power cable to the printer.
•
Connect the power cord to the power cord connector at the back of the printer.
•
Connect the other end of the power cord to the power outlet.
e
- 20 -
Recommend Distance
a
910 mm
b
210 mm
c
830 mm
d
180 mm
e
300 mm
Advertisement
Table of Contents
