Table of Contents
Advertisement
3.3.2
Setting IP address
1.
In Copy Mode, press <Menu> on the control panel. Press <▼> for four times and press <Set>.
2.
On the Password screen, press <0> four times, press <Set>.
3.
On the Network screen, press <Set>.
4.
Select Ethernet, TCP IP, or Protocol with <◄/►> and press <Set>.
5.
In the IP address screen, select the desired option <◄/►> and press <Set>.
6.
Enter the IP address with the numeric keypad and press <Set>.
7.
Need Power off message messages appears within a few seconds.
8.
In the Network screen, press <Copy> or turn the power off and on.
Password
Note:
•
For detail instructions on Network configuration setting, please see the chapter 10 troubleshooting
guide, "10.10.10.4 <Menu> key" section
•
When you finished IP address change or modify, please switch power OFF then ON again, otherwise
changed IP address will not available.
3.3.3
Setting languages mode
Refer to the menu tree below to select the languages and insert the toner cartridges when using the device for
the first time
Configuration
MENU
Need Password
Not Match
Invalid
▲
Password ?
Input : ****
SET
Configuration
Network
SET
Network Config
Ethernet
Network Config
TCP/IP
SET
TCP/IP
IP Address
SET
IP Address
XXX.XXX.XXX.XXX
SET
Need Power Off
To Enable
- 23 -
▲
Match
▲
◄►
▲
◄►
▲
◄►
▲
◄►
▲
Advertisement
Table of Contents
