Miscellaneous; Save & Restore - Gigaset N300 IP User Manual

Saving and restoring system settings
Once you have configured your base and after each configuration change, you can
save the current base settings in a file on the PC (suffix .cfg).
If you change the settings accidentally or you need to reset the base due to a fault
(base reset), you can reload the saved settings from the file on your PC to your
phone.
The contents of the .cfg file include:
u
The settings for the local network (IP configuration)
u
The data for the (VoIP) connections established
u
The assignment of send and receive connections
u
Your own local area code and access code
u
The network mailbox number
u
The Internet services settings
u
The ECO DECT settings.
You can save and restore the system settings via the Web page:
¢
Settings Management
Changing the base settings, registering handsets
You can use the Web configurator to:
u
Switch the base to registration mode to register handsets to the base. This set-
ting corresponds to pressing and holding the Registration/Paging key on the
front of the base.
u
Activate/deactivate Eco Mode or Eco Mode+. For Eco Mode see
u
Change the system PIN
u
Activate and deactivate the LED for the Registration/Paging key on the front of
the base. See page 2
u
Activate/deactivate the display of VoIP status messages on your handset.
The base settings are on the Web page
¢
Settings Management
Configuring the phone via the Web configurator
¢
Save & Restore
¢
( page 121) for your phone.
for the meaning of the LED.
¢

Miscellaneous

page 110.
159