Disabling Dhcp In The Max 4; Entering A Static Ip Address; Entering A Net Mask Address; Logging In To The Max Web Manager - Net2Phone MAX 4 Quick Start Manual

Voip gateway
Hide thumbs Also See for MAX 4:
Table of Contents

Advertisement

4. Reset the MAX 4.
5. Log into the MAX Web Manager.
6. Set the required configuration parameters in the MAX Web Manager.

Disabling DHCP in the MAX 4

Since the Net2Phone MAX 4 is shipped with DHCP enabled, you need to disable DHCP to
use static IP addresses. To disable DHCP, proceed as follows:
1.
Lift the telephone handset and dial ***5. The voice prompt announces, "DHCP is
disabled now. Please press pound."
2.
Press the pound key (#).
3.
Hang up the telephone.
DHCP is now disabled.

Entering a static IP address

1. Lift the telephone handset and dial ***2. The voice prompt responds, "Please enter
your IP address."
2. Dial the IP address numbers you wish to enter on the telephone keypad. Use the
star key (*) to replace the periods in the address and end with a pound sign ( #).
For example, if you want to enter the IP address "192.168.172.19," you would enter
192*168*172*19# from your telephone keypad. The voice prompt responds, "Your
address is..." and repeats the address you entered.
3. If the new address is correct, simply hang up the telephone. If the new address is
incorrect, hang up the telephone and repeat from step 1, above.

Entering a net mask address

1. Lift the handset and dial ***3 (the subnet mask parameter code). The voice prompt
responds, "Please enter your net mask."
2. Enter the net mask address from the telephone keypad using the same format that
you used to enter the IP address (e.g., 255.255.255.0#)
3. Reset the Net2Phone MAX 4 to activate the changes. To do this, power-off the unit,
wait 10 seconds, and turn it on again.
If your LAN is using stati c addresses, you can now finish configuring your system
using the MAX Web Manager. Proceed to "Logging into the MAX Web Manager," below.

Logging in to the MAX Web Manager

Now that you know the Net2Phone MAX 4's IP address, you are ready to log in to the MAX
Web Manager through a Web browser as follows:
1. Using a computer connected to the same network as the MAX 4, open a browser
window and enter the IP address of the MAX 4 in the URL (Internet address) box
Page 4

Advertisement

Table of Contents
loading

Table of Contents