Error Messages - Microlife WatchBP Office Central Instruction Manual

Error messages

If an error occurs during measurement, the
measurement is interrupted and an error message
«Err» is displayed.
F
Please contact your local
Microlife service center if the error
persists.
F
If you think the results are
unusual, please read through
the information in this instruction
manual carefully.
33
Error Description
Err 1 Signal too weak
Err 2 Error signal
Potential cause and remedy
The pulse signals on the cuff
are too weak. Re-position
the cuff and repeat the
measurement.
During the measurement,
error signals were detected
by the cuff, caused for
instance by movement or
muscle tension. Repeat the
measurement, keeping your
arm still.