Before You Begin
These operating instructions describ e the op tiset E entry telephone
on your HiPath 300 0/HiPath AllServe.
They describe all functions you can use from your telephone. You may find that some func-
tions you wish to use are not available on your telephone. This may be due to one of the
following reasons:
•
The function has not been configured for your telephone - address any questions to
Customer Support.
•
Your communications platform does not support this function - contact your Siemens
sales representative to upgrade your system.
How to Use these Operating Instructions
Step by Step
2
You will find a graphic representation of the steps
in logical sequence in the left column. Below is an
explanation of the symbols:
Lift the handset.
Replace the handset.
Conduct a call.
Enter a telephone number or code.
Enter the PIN.
or
Press volume controls on the telephone.
You hear a tone.
A long tone (positive confirmation tone) confirms that
you have successfully activated a function or procedure.
A short tone (negative confirmation tone) indicates that
the function or procedure was rejected.
Press the key.
Press the illuminated key.
Press the flashing key.